Holes are drilled into concrete slab and filled with epoxy.
	Workmen install threaded rods into epoxy-filled holes.
	Flashing and bracket installed on slab - ready for exterior wall panel installation.
	Floor-to-wall bracket with hold-down bolt installed for interior wall panels.
	Putting up wall panels with factory-installed, double-hung windows.
	Wall panels are in place. Roof truss brackets installed.
	Roof trusses are pre-assembled at the factory and "collapsed" for easy shipment. Workmen "unfold" each truss and insert screws.
	Gable roof trusses are assembled on work benches. The completed trusses are ready to install.
	All truss members are securely screwed together with ¼" Tek screws for maximum strength.
	Workers use an air wrench to fasten roof trusses to exterior walls with a bolt and washer.
	Assembled roof trusses can be installed on most houses without a crane.
	Top-hat steel purlins are screwed into steel trusses with ¼ inch Tek screws at every intersection.
	The roof is framed and ready for siding and sheeting.
	Horizontal cement-board clapboard siding is installed on the gable ends.
	Pre-painted roof sheeting is installed with typhoon assembly screws over fiberglass insulation.
	Pre-painted, pre-cut roof sheeting installs easily. This is the six-rib standard specification Force 10 roof sheeting.
	A completed, weather-tight shell.
	Pre-cut and pre-tabbed ceiling battens facilitate installation of gypsum-board ceiling.
	Finishing off the interior: wall panels are taped and plastered, gypsum-board ceiling is taped and plastered, a gypsum cornice is glued into place.